View the Products in Environmental Monitoring

ENVIRONMENTAL
Monitoring

Sampling and monitoring instruments for air, water and soil for the environmental, agricultural, mining and forestry markets.

View the Products in Environmental Monitoring
View the Products in Geotechnical and Materials Testing

GEOTECHNICAL & MATERIALS Testing

Materials and Product testing for soil, asphalt, petroleum, concrete, cement, food and cosmetic industries.

View the Products in Geotechnical and Materials Testing
View the Products in Test and Measurement Instrumentation

TEST & MEASUREMENT
Instrumentation

Sensors, transducers and instrumentation for industry, manufacturing, research and development and factory automation.

View the Products in Test and Measurement Instrumentation

Bronkhorst CEM Systems for NASA Research

March 3, 2017
Category: News

From BronkhorstUSA.com:

The National Aeronautics and Space Administration (NASA) recently redesigned the system used to test the new space suit Portable Life Support System (PLSS) that is under development. In order to test the PLSS a simulated human metabolic load must be applied to the various sub-systems and so NASA needed to simulate the human production of CO2 and water vapor with its associated heat load.

nasa-1

Working closely with NASA engineers to fully understand the application requirements, Bronkhorst learned that accurate, stable control of water vapor was critical to efficient and repeatable testing and therefore successful development of the PLSS.

The recommended Bronkhorst solution was a CEM system to properly control the mass of water being vaporized as well as the amount of CO2 in the vapor. NASA has three CEM systems connected to an outlet manifold. Each CEM system consists of a liquid mass flow controller (H2O), a gas mass flow controller (CO2), a Controlled Evaporator Mixer, and a readout/control unit. The three connected CEM systems are collectively referred to as the Human Metabolic Simulator (HMS).

nasacems

The Bronkhorst HMS equipment is controlled via analog (0-5 Vdc) signals through the Bronkhorst readout/control units (1 per CEM system) which in turn are connected to the NASA main test system running NASA’s customized LabVIEW software.

This setup allows NASA to simulate those aspects of human metabolic output up to a rate of ~3500 BTU/hr, or a bit over 1000 Watts, by injecting the CO2/water vapor mix into a simulated spacesuit volume containing a manikin (“Manny”) which is wearing a Liquid Cooling and Ventilation Garment (LCVG). The LCVG removes sensible heat to keep the human core temp in nominal range, and also provides some latent heat removal via condensation of human-generated water vapor on the surface of the cooling tubes.

To complete the human metabolic load simulation, NASA has placed controllable heaters on the CO2/H2O vapor deliver lines to prevent condensation and to add super-heat as needed. Additionally, they have controllable electric heaters on the manikin body to simulate sensible heat generation by a human being working at various levels of effort. There is also a Bronkhorst Mass Flow Controller to remove gas from the suit at rates that simulate metabolic consumption of suit gas as well as suit leakage.

Hoskin Scientific carries a wide variety of products from Bronkhorst. Click here to see their range of solutions to match your instrumentation and testing needs.

Comments

Comments are closed.