View the Products in Environmental Monitoring

ENVIRONMENTAL
Monitoring

Sampling and monitoring instruments for air, water and soil for the environmental, agricultural, mining and forestry markets.

View the Products in Environmental Monitoring
View the Products in Geotechnical and Materials Testing

GEOTECHNICAL & MATERIALS Testing

Materials and Product testing for soil, asphalt, petroleum, concrete, cement, food and cosmetic industries.

View the Products in Geotechnical and Materials Testing
View the Products in Test and Measurement Instrumentation

TEST & MEASUREMENT
Instrumentation

Sensors, transducers and instrumentation for industry, manufacturing, research and development and factory automation.

View the Products in Test and Measurement Instrumentation

ARAMIS – From 3D Measuring Data to Vibration Types

February 22, 2019
Category: News

The article below is from GOM website.csm_news_aramis-vibration-types

Calculation models show the type of vibration of parts. Measurements are carried out to help to understand which types of vibration are formed during operation of the part. GOM offers the sensor system for carrying out these measurements.

The ARAMIS 3D sensor is a stereo camera system and provides accurate 3D coordinates using the triangulation principle. The sensor measures 3D coordinates dynamically and provides measuring results such as strains, 3D displacements and 3D deformations. The 3D displacements captured with a high temporal resolution are used for the vibration analysis. The optical metrology offers many advantages for the vibration analysis such as:

  • Non-contact measuring principle
  • No wiring of accelerometers required
  • Fast setup and calibration of the sensor
  • Compact dimensions of the sensors
  • Ultra-light and lasting measurement targets
  • Synchronous measurement of many points in 3D – thus points can be measured also unsteadily
  • 3D displacement results for each measuring point

Depending on the application, measurements on the part are carried out in a point-based or full-field manner. To specify the type of vibration with the ARAMIS sensor, the excitation of the parts can be different. A simple harmonic excitation, an impact test or a rotating part during operation can be measured. The frame rate depends on the excitation. The ARAMIS SRX system of the ARAMIS sensor family has a maximum image recording rate of 335 Hz with a 12-megapixel resolution. In addition, by reducing the image height, the image recording rate can be increased up to 2000 Hz.

From the captured image data, surface components or point components are created. These components are inspected for 3D displacements over time.

Read more -> Here

Comments

Comments are closed.