Two different models, both equipped with low liquid-level controllers in accordance with the latest ASTM specifications. Two-unit water analog-controlled water bath can be flush mounted in a table top if desired, and is equipped with an overflow standpipe/drain to maintain the proper depth when the pressure vessels are inserted, and a plated brass reflux condenser to minimize evaporation loss.
The four/six-unit model can be used with water or oil as a bath medium, and has microprocessor temperature control that provides quick temperature stabilization without overshoot. Dual LED displays provide setpoint and actual temperature values in °C/°F format. A built-in overtemperature control circuit interrupts power should the bath temperature exceed a programmed cut-off point. Both models feature double-wall insulated construction with stainless steel tanks, support racks and port covers. Order thermometer separately. The four/six unit model can be ordered with interchangeable racks for performing the ASTM D942, ASTM D323 and D1298 test methods. Please contact your Koehler representative for additional information
Communications software (RS232, etc.) ramp-to-set and other enhanced features are available as extra cost options. Contact your Koehler representative for information.
Conforms to the specifications of: ASTM D525, D873; IP 40, IP 138; ISO 7536; DIN 51780, 51799; FTM 791-3352, 791-3354; NF M 07-012, 07-013
Two-Unit Liquid Bath: boiling water
Four/Six-Unit Liquid Bath: 250°F (121°C)
|Electrical Requirements||Heater Range||Dimensions|
|115V 50/60Hz, 17.3A||0-2000W||24x14x24|
|G-142-K10402||220-240V 50/60Hz, 9.0A|
|220-240V 50/60Hz, 18.1A||0-3000W||24x14x29.5|
|G-142-K10540||Glass Sample Container and Cover with pour out spout|
Replacement composition gasket for K10500 Oxidation Pressure Vessel.
For pressurizing Oxidation Pressure Vessel. 6 ft. (1.83m) long, with quick release coupling for needle valve on pressure vessel and threaded fitting for oxygen tank.
|G-142-K10556||Oxygen Manifold Pressure Relief System.|
Connects to oxygen source to prevent overcharging of vessel. Equipped with relief valve to vent at 125psi and 300 series stainless steel 150psi burst disk assembly. Constructed from 300 series stainless steel. Cleaned for oxygen service.
For tightening seal on Oxidation Pressure Vessel.
Installs in benchtop to aid in tightening seal on Oxidation Pressure Vessel.
For connecting pressure recorder to vessel. Flexible seamless helical tubing with protective armor braid and connections. 5 ft (1.52m) long.
|G-142-K10525||Burst Disk Assembly.|
Retrofit kit for Oxidation Pressure Vessel without burst disk assembly.
|G-142-250-000-22F||ASTM 22F Thermometer|
Range: 204 to 218°F
|G-142-250-000-22C||ASTM 22C Thermometer|
Range: 95 to 103°C